Fed up with flat tyres? The Z Liner is a protective tape made out of highly resistant polyurethane material and provides additional protection against the risk of getting a puncture. The Z Liner is positioned between the inner tube and the tyre to prevent getting a flat tyre. Various sizes are available depending on your tyre width. Sold in pairs. Ride along in peace thanks to the Z liner.
Made from polyurethane
Highly resistant to punctures.
High level of quality
Particularly long product lifespan.
- 9721: 2 x 60g
9722 : 2 x 35g
9723 : 2 x 135g
9738 : 2 x 90g
- 9721 : orange
9722 : grey
9723 : purple
9738 : blue
- Wheel Ø
- All diametres
- Tire width
- 9721 : Hybrid / Gravel 35 mm, 38 mm, 40 mm
9722 : Road 23 mm, 25 mm, 28 mm
9723 : MTB 2.4'', 2.6", 2.8", 3.0"
9738 : Hybrid / Gravel 47 mm, MTB 2.0'', 2.1", 2.2", 2.25"
- 9721: 27 mm
9722 : 19 mm
9723 : 50 mm
9738 : 34 mm
Our advices and commitments
1- Installation is done when fitting the tyre.
2- Rest the tyre flat on a table.
3- Mount the inner tube by starting with the valve. Carefully inflate until it falls into place.
4- Slide the Z Liner between the inner tube and the tyre.
5- Roll out the Z Liner and insert it opposite the valve.
6- Cut the tape with a pair of scissors being careful to leave a 2 cm gap between the two strips which will help stop the tapes overlapping and pinching the inner tube. A squashed inner tube is more likely to puncture.
7- Check the Z Liner is in the correct position before adding the rest of the tyre and inflating it to the right pressure.
Product designed by our R&D department in France.
The commitment to quality is one of our major concerns. If you encounter any difficulties with this product, please contact our quality department.